Using our made to measure tool, please select the Bircher S-Line profile required (noting overtravel figure shown below), then the termination type, cable length, mounting profile and the length of the safety edge. Finally, enter the required length in mm, click calculate and then add to your basket.
Important: Please ensure that the safety edge is suitable for your application and the overtravel figure meet the demands of your application..
Our Bircher S-Line edges are available are safety edges with a self-adhesive, C-Channel or CoverLine style mounting. The "Click" foot of the profile makes installation of the edge a simple task of clipping them in from the side of the profile.
Safety edges are manufactured in two formats a “pass through” or “link” version with two cables and the “end-of-line” version with 8k2 terminating resistors. Up to four edges (as recommended by Bircher) can be are wired together in series with each other with the 8k2 version being the last link in the chain. The switching unit monitors the resistance of the series of safety edges, if any of the edges in the chain are compressed this will cause the safety relays on the switching unit to open, also if any of the cables in the circuit are damaged the unit will show this as a fault and the safety relays will be opened.